How to Guide

2
III. HOW TO INSERT THE DESIGNER DRAIN
GRATE INTO THE TILED SHOWER PAN SO
THAT (A) IT IS SPACED CORRECTLY FOR
DRAINAGE AND (B) IT IS AT THE SAME LEVEL
AS THE ADJACENT TILE: (See Figs. 1 & 3)
1. Select a combination of Vertical Drain
Spacers (2mm, 4mm, and/or 6mm) so that
the top surface of the Designer Drain Grate
is at the same level as the top of the floor
tiles adjacent to the trench.
2. Insert the Rubber Bumpers into the
Designer Drain Grate side holes by
inserting them into the holes until they are
locked in place (Fig. 1).
3. Slide the Designer Drain Grate into the
shower pan Trench Recess, first by
compressing the side of the grate with the
Rubber Bumpers against the wall of the
shower pan Trench Recess (Fig. 3).
4. Finally, slide the other side of the Designer
Drain Grate into the shower pan Trench
Recess.
IV. HOW TO REMOVE THE DESIGNER DRAIN
GRATE FROM THE TRENCH RECESS: (See Fig.
4)
1. Insert your fingers or an Allen wrench into
the space between the Designer Drain
Grate and the Trench Recess wall (i.e.,
either between E and F or between G and
H), carefully lift out one side of the grate
and grab it with both hands and then
carefully remove the other side by lifting
the entire grate with your hands.