User manual

3G Cell Modem Upgrade for BaseStation 1000 Controllers in Pedestals
Page 4
4. With the antenna and Ethernet cables pointing up and the power cord pointing down, align
the two mounting holes on the right side of the 3G cell modem module with the standoffs on
the back wall of the pedestal. Use the screws provided to secure the board to the enclosure.
5. Plug the 5-pin connector from the 3G cell modem power cord into one of the 5-pin
connectors on right end of the controller board.
Note: The illustration shows the black plastic dust cover removed from the controller board;
however, you can install the 3G cell modem without removing the dust cover.
6. Plug the other end of the Ethernet cable into the Ethernet jack on the back of the display
board.