User guide

Table of Contents
Introduction ....................................................................................................................... 1
Gather the Following Tools and Materials .......................................................................... 1
Step 1 – Assemble the Antenna Riser .................................................................................. 2
Step 2 – Prepare the Mounting Location for the Antenna Riser ............................................ 3
Step 3 – Attach the Antenna Riser to the Pedestal ............................................................... 4
Step 4 – Install the 3G Cell Modem Hardware ..................................................................... 4
To install the cell modem hardware ...................................... Error! Bookmark not defined.
Step 5 – Check Your Firmware Version & Update if Necessary ............................................. 6
BaseStation 1000 Instructions ............................................................................................. 6
To check the version of firmware on your BaseStation 1000 controller ........................ 6
To update the BaseStation 1000 firmware from the Baseline web site ......................... 7
BaseStation 3200 Instructions ............................................................................................. 7
To check the version of firmware on your BaseStation 3200 controller ........................ 7
To update the BaseStation 3200 firmware from the Baseline web site ......................... 7
Step 6 – Activate Your SIM Card with Baseline .................................................................... 8
Step 7 – Verify the Cell Modem Connection in the Controller .............................................. 8
BaseStation 1000 Instructions ............................................................................................. 8
BaseStation 3200 V12 Instructions ................................................................................... 11
Setting the Data Usage Mode ...................................................................................... 12
Page i