Installation Instructions
UM-19-016 5 2/16/2021
PRODUCT WARNINGS
PLEASE READ BEFORE OPERATING OR INSTALLING
ANY BASE SYSTEM
Air solenoids used to control the tank internal valves should be
connected to the same air supply for the DOT required MANUAL
Emergency Stop switch(es). Following activation of the radio remote
Emergency Stop feature, the operator MUST first close the manual
internal valve switch prior to resetting the BASE system. Failure to do
this may result in the internal valve(s) automatically and unintentionally
reopening with system reset.
Systems wired ‘hot’ to power when the vehicle is in motion have ALL
remote functions still operable. A driver (or passenger) may
accidentally activate the remote control, unintentionally causing the
Emergency Stop feature to activate and the truck’s engine to stop
instantly. Systems must be properly interlocked to prevent unintended
use.
AN UNINTENTIONAL ENGINE SHUT DOWN WHILE THE VEHICLE
IS IN MOTION MAY RESULT IN SERIOUS INJURY OR DEATH.
Never attempt to perform PTO repairs from under chassis while
engine is running or while wearing radio remote control device.
All open valves must be closed prior to system reset to prevent the
valve from automatically and unintentionally reopening with Emergency
Stop reset.
DO NOT CONNECT CHASSIS GROUND TO EITHER OF THE HOSE
REEL MOTOR ELECTRICAL LEADS WHEN USING A REMOTE
CONTROL POLARITY REVERSE CIRCUIT. BOTH LEADS MUST BE
CONNECTED DIRECTLY TO THE CONTROLLER AS SHOWN IN
THE SUPPLIED SYSTEM DRAWINGS.
UM-19-016 6 2/16/2021
PRODUCT WARNINGS CONT’D
NEVER GO UNDER A TRUCK WITH THE ENGINE RUNNING AND
NEVER USE THE REMOTE CONTROL DEVICE TO ACTIVATE THE
PTO WHEN WORKING ON OR SERVICING THE PTO FROM
UNDER THE TRUCK. THE REMOTE CONTROL DEVICE IS
INTENDED TO BE USED ONLY WHEN THE OPERATOR IS NOT AT
RISK OF BEING INJURED BY THE MACHINE.
AN UNINTENTIONAL USE OF REMOTE WHILE WORKING ON THE
TRUCK MAY RESULT IN SERIOUS INJURY OR DEATH.
Do not mix different brands of batteries or used and new batteries.
Unauthorized modifications to any BASE system or any unintended
uses of BASE systems may void the manufacturer’s warranty for the
product. This may include, but is not limited to, drilling holes in BASE
product enclosures, adding auxiliary or bypass switches, changes to
installation procedures, modifications to antennae configurations, or
changes to the electronic or mechanical workings of the system.