Installation Guide

4 Cut the wall U-Channel to length
properly using the below formula:
U-channel Height = Unit Height - 3/4”
Next, drill three 3/16” diameter holes in the cen-
ter of U-channel (centerline groove provided for
convenience); one hole 6” from each end and
one hole in the middle. Place the U-channel
over the wall centerline marked in step one.
With a pencil, carefully mark each hole position
on the wall centerline. Drill a 3/16” diameter
hole, approximately 1” deep, directly on the wall
centerline at the marked locations.
3 Insert a small amount of silicone into each drilled hole, then insert a wall anchor into each hole.
(Note: Drill hole, then insert a wall anchor.) This must be done just before u-channel installation.
Carefully cut the heads off the wall anchors with a razor blade. Place the U-Channel in correct posi-
tion and secure it with #8 x 1-1/2” truss head screws.
QCI5279 Rev. 0 Page 7 of 15 Date Certified: 06/21/2016