Installation Guide

17 On the interior face of the glass, place
a strip of low tack tape on the glass about 1/8”
to 3/16” away from edge of the u-channel both
vertically and horizontally. Run a small bead of
silicone along this edge. Next, on the interior,
run a bead of silicone between the u-channel
and the threshold and also between the u-
channel and the wall. After completing, remove
the tape before silicone sets.
Repeat silicone application process to outside
of door. Apply between fixed glass panel and u
-channel, u-channel and wall, u-channel and
threshold.
NOTE: DO NOT USE the shower until the silicone is completely cured. Check the tube
of silicone for the manufacturer recommended cure time (typically 24 - 48 hours).
QCI5279 Rev. 0 Page 14 of 15 Date Certified: 06/21/2016