Installation Instructions
QCI5279 Rev 1 Page 16 Cered 08/09/16
20 Using a small Allen Wrench in the adjuster holes around the perimeter of the Roller, adjust the
door panel to match the Fixed Panel height and create an even gap at the wall.
Tighten the Roller Mount when adjustment is complete.
21A Adjust the Anti-Jump has an offset mount to allow for adjustment. Adjust the Anti-Jump so
that it is installed with a 1/16” or less between the itself and the header bar. Tighten the mounting
screw when adjustment is complete.
21B Align the bottom rollers as shown. Adjust the
Bottom Rollers so that they are centered vertically with the
Top Rollers. The Bottom Rollers are intended to, but may
not make full contact with the header bar.
Tighten all fasteners to secure position of rollers.
22 Disassemble the Pull Handle and install on the Door Panel. The Handle should be on the
outside of shower and the Knob on the inside. Install the Knob through the bottom hole..