Installation Instructions

QCI5279 Rev 1 Page 15 Cered 08/09/16

18 Carefully loosen the Roller Mounts to allow the Door Panel to move to its lowest setting. Lower-

ing the door allows for the next step.

CONTINUE TO 19A IF INSTALLING ANTI-JUMPS

CONTINUE TO 19B IF INSTALLING BOTTOM ROLLERS

17 Disassemble two Roller Assemblies and loosely secure to

Door Panel Glass.

The Rollers have an offset mount to allow for adjustment. While

mounted onto the Door Panel, rotate the rollers to their lowest po-

sition so that the Door Panel does not hit the ground or U-Channel

during installation. Tighten the Roller Mount

Then carefully lift the door panel into place so the rollers rest on

top of the roller bar assembly.

19A—INSTALLING ANTI-JUMPS

Disassemble the Anti-Jump and install it below the roller bar as-

sembly in the two holes provided to hold it in place. Leave the

Anti-Jump Assemblies loose for future adjustment.

CONTINUE TO 20 and 21A

Roller

Mount

Anti-Jump

Assembly

Header Bar

Roller

Mount

19B—INSTALLING BOTTOM ROLLERS

As in Step 17, Disassemble two Roller Assemblies and loosely se-

cure to Door Panel Glass. Leave the Bottom Rollers loose for fu-

ture adjustment.

CONTINUE TO 20 and 21B