Installation Sheet

PANEL
QCI5022 REV.4
7
Slide anti-jumps
into position:
1) at left wall jamb
2) at right wall jamb
3) centered in
opening
Insert 1 SCR11 screw into the pre-drilled hole of each insert. The screws will just press against the header. DO NOT use power
tools to insert these screws. DO NOT drill the header for these holes.
PRO TIP!
If the rollers contact the
ant-jump during normal
opperation, back the screw
out of the insert 1/4 of a
turn at a time until less
contact is made.
If the rollers are able to
jump from the track slowly
tighten the screw 1/4 of a
turn at a time until the
roller is unable to jump
from the track.
Certified 11/24/2020