Installation Guide

Textured glass lites [G] should be installed with the
textured surface to the exterior of the unit.Clear
glass does not have a preferred side to face out. If
your unit was purchased with AquaglideXP be sure
the treated surfaces are installed to the inside of the
shower
If not installed from the factory, install the hanger
brackets onto the glass. On the outside panel, the
roller is installed to the outside. On the inside panel,
the roller is installed to the inside.
8
ROLLER
BEARING
HEADER
GLASS
PANEL
ROIRETNI
LENAP
HANGER
BRACKETS
ROIRETXE
LENAP
QCI5022 REV.3
7
Slide anti-jumps
into position:
1) at left wall jamb
2) at right wall jamb
3) centered in
opening
Insert 1 SCR11 screw into the pre-drilled hole of each insert. The screws will just press against the header. DO NOT use power
tools to insert these screws. DO NOT drill the header for these holes.
PRO TIP!
If the rollers contact the
ant-jump during normal
opperation, back the screw
out of the insert 1/4 of a
turn at a time until less
contact is made.
If the rollers are able to
jump from the track slowly
tighten the screw 1/4 of a
turn at a time until the
roller is unable to jump
from the track.
Certified 10/12/17