Installation Guide

WALL
JAMB
NYLON
SPACER
#8 x 2” TRUSS
HEAD SCREW
Replace one wall jamb [B] and attach to the
wall with a #8 x 2” truss head screw [D] inserted
through the center hole. Slip a nylon spacer [E] over a
#8 x 2” truss head screw and install in the top hole
of the wall jamb. Repeat for the bottom jamb. Check
jamb for plumb and tighten screws.
NOTE: Do not over-tighten the jamb screws.
4
This bath enclosure is equipped with safety tee
-
lock wall jambs. When installed properly, the header is
permanently locked to the wall jambs and cannot be
accidentally dislodged.
Measure the wall-to-wall opening at the top of the wall
jambs [B] and cut the header [F] 1/16” short of this
dimension. Check the header for fit.
Slide the safety tee-lock of the unmounted wall jamb
into the header.
Holding the header at an angle, engage the end onto the
mounted wal
l jamb. Pivot the header into place, then
slide the loose wall jamb to
the wall and press into
position on the tub track. Attach to the wall per
instructions in Step #4.
5
6
HEADER
WALL
JAMB
#8 x 2” TRUSS
HEAD SCREW
QCI5022 REV.3
If not already, slide the anti-jump inserts to the center of the header.
NOTE: Header shown
and cut away for clarity
Certified 10/12/17
HEADER
ANTI-JUMP