Installation Guide

Before installing the door panels, the proper

orientation should be determined. For maximum water -

proofing, the interior panel should always be positioned

closest to the shower head, as shown in this illustration.

Slide one of the clear plastic discs [J], then

a glass hole sleeve [K] onto the back plate [I]. Push

the assembly through the hole in the glass panel,

so that the glass hole sleeve is flush with the other

side of the panel. Slide the other clear plastic disc

onto the protruding end of the back plate, and then

slide on the front plate [L]. Repeat this for the second

hole on the panel. While holding the towel bar [N] in

place, and screw the back plates into the towel bar.

NOTE: Outer panel has towel bar facing Out.

Inner panel has towel bar facing In.

QCI5022 REV.3

Certified 10/12/17