Installation Guide

QCI0237 Page 9 of 10 Certified 11/01/10
14 Inspect the strips of black glazing vinyl and note
the two different profiles. The flat shaped vinyl [U] is
installed vertically and the crescent shaped vinyl [V] is
installed horizontally
. There should be a total of eight (8)
individual vertical and eight (8) individual horizontal
pieces of vinyl about a 1/2” wide each. (May need to
peel apart from a wider strip).
These vinyls are designed to fit tightly between the glass
and metal frame. TIP: Wet the glass and vinyl with water
or glass cleaner immediately before installing vinyl and
use a small block of wood to press the vinyl into place.
NOTE: Different glass sizes require different vinyl. Refer to
the chart for clarification if installation is extremely difficult.
15 Cut the eight (8) pieces of vertical vinyl [U] 1”
longer than the vertical opening. Verify that the depth
of the glass into the post and wall jamb is sufficient and
even (refer to Step #6).
Starting on the exterior
, slide one end of the vertical vinyl
up into the header and press it into the wall jamb about 6”
down.
Apply light pressure against the interior of the glass panel
to hold the exterior vinyl in place and install vinyl on the
interior in a similar fashion. Press the vinyl into the wall
jamb alternating between the interior and exterior
.
Remove the tape from glass surface before installing the vinyl.
Caution: Do not to stretch the vinyl when pressing into place.
Repeat above steps for the corner post.
VERTICAL
OPENING
GROOVE GROOVE
**Skip steps 14 - 16 if Quick ‘N Stall option was selected**
#6-32 x 1 1/4”
HANDLE SCREWS
INTERIOR
HANDLE
DOOR
STRIKE
RAIL
INTERIOR
HANDLE
EXTERIOR
HANDLE
EXTERIOR
HANDLE
MAGNETIC
VINYL
STRIKE
JAMB
1/8”
13 Attach the interior door handle [R] and
exterior door handle [S] to the door panel with
the two #6-32 x 1 1/4” round head screws [T].
Close the door and check the clearance with
the strike jamb. Loosen and adjust if necessary
.
GLAZING
VINYL
CORNER
POST
WALL
JAMB
GLASS
PANEL
OVERHEAD
VIEW: