Installation Guide

QCI0237 Page 8 of 10 Certified 11/01/10
11 Clean the bottom door rail and the drip
rail [M] thoroughly to ensure proper adhesion.
Unroll the double stick tape [N] and carefully
apply it to the flat back side of the drip rail.
(DO NOT peel the tape backing yet)
Insert the tapered drip vinyl [O] with the short
side of the vinyl on the hinge side of the rail.
Position the drip rail so that the bottom is flush
with the bottom of the door rail on the hinge side,
and is 1/16” from the continuous hinge jamb.
(see illustration)
Raise the drip rail on the strike side until the
bottom edge of the tapered drip vinyl is parallel
to the curb. Mark the horizontal location of the
drip rail on both sides.
DOOR
RAIL
DRIP
RAIL
TAPERED
VINYL
ALIGN
(HINGE
SIDE
ONLY)
STRIKE
SIDE
HINGE
SIDE
1/16”
PARALLEL WITH CURB
MARK
MARK
TAPERED
DRIP VINYL
3/8”
1/8”
DRIP
RAIL
TAPERED
VINYL
#6 x 3/8”
SCREW
12 Hold the drip rail in place and adjust the drip
vinyl by sliding it left or right until there is a 1/16”
gap between the bottom of the vinyl and the top of the
snap-in-filler
. Trim the vinyl flush with the hinge side
of the rail and 3/8” longer on the strike side. Notch the
top of the drip vinyl. (see illustration)
Install the #6 x 3/8” screw [P] into the hinge side of the
drip rail. Separate the two drip plugs [Q] and install the
correct one into the strike side of the drip rail. Discard
the other unused plug.
Peel of
f the tape backing and carefully press the drip
rail assembly to the door in the marked position.
TIP: Place a small bead of silicone along the top of the
drip rail between the rail and door frame to help prevent
water and cleaners from loosening the tape over time.
1/16”
CURB
SNAP IN
FILLER
DRIP
PLUGS