Installation Guide

QCI0237 Page 6 of 10 Certified 11/01/10
CURB
WALL
JAMB
SETTING
BLOCK
GLASS
PANEL
GLASS
PANEL
CORNER
POST
1/2”
1/2”
PIECES OF TAPE
SETTING BLOCKS
7 Using a 3/16” high-speed steel drill bit,
drill the interior face of the header assembly on
both ends where it meets the wall as shown.
These holes may be pre-drilled from the factory
.
HEADER
3/16” DIA.
3/8”
5/16”
INTERIOR
8 Press the header assembly over the wall
jambs and corner posts. Check both sides of each
corner post for plumb. Adjust as required by
varying the overlap of the header over the wall jambs.
Using the 3/16“ holes in the ends of the header and
curb as a guide, drill four 1/8” holes into the wall
jambs. Also, drill two holes through the header and curb
and into the corner post as shown. Enlar
ge the holes
in the header and curb only, not the post, to 3/16” to
allow for clearance of the screws. Secure the header
and curb to the wall jambs and corner post using
eight #8 x 1/4” truss head screws [B].
CAUTION: Slide the glass panel away from the walls and
posts when drilling to prevent the glass panel from breaking.
HEADER
ASSEMBLY
CURB
ASSEMBLY
WALL
JAMB
CORNER
POST
NOTE: If the Quick N’ Stall option was selected,
the setting blocks are not used.
Set the glass panel in place and press
down until it snaps into the curb.
6 Place four setting blocks [G] into the curb, flat side
up, to support the stationary glass panels (two blocks per
panel). Position the blocks so they are centered about 3”
from each corner of the glass panels. Set the stationary glass
panels [H] into the curb on the setting blocks and slide into
the wall jamb approximately 1/2“. A
piece of tape
positioned 1/2” from the vertical edge will help placement.
NOTE: Patterned glass panels should be installed with
the rough or patterned surface on the exterior
of the enclosure.
Press the corner posts [I] into the curb assembly. They
should overlap the return glass panel by 1/2“. Use
masking tape to hold their position temporarily.
NOTE: Depending on any out of plumb or level conditions,
the panel/metal overlap might vary from 1/4” to 3/4”. Use a
level to determine if this is necessary
.
5/16”
”4/1
5/16”
OPENING
NOTE: If the Quick N’ Stall option was
selected, put the header in place
and press down until it snaps
over the vinyl.