Installation Guide

QCI0237 Page 4 of 10 Certified 11/01/10
ANCHOR
PLATE
#8 x 1/4”
SCREWS
MITERED
CURB END
MITERED
CURB END
HINGE RIGHT
HINGE LEFT
1 The Framed Continuous Hinge
Shower door panel is completely reversible and
may be installed hinge right or hinge left. For maximum
waterproofing, the door should hinge off of the panel
opposite the shower head wall. (see illustration)
Careful as to not follow the illustrations exactly.
CAUTION: For safety reasons, the door must
always open outward.
TIP: Temporarily cover the drain on the inside of the
shower with some tape or a large piece of cardboard
to prevent small parts or screws from disappearing.
2 Assemble the three curb sections (w/ weep
holes) [A] by sliding an anchor plate into the
mitered ends and forcing the sections together. The
weep slots in the curb must be to the inside. Using
the slotted holes in the anchor plate as a guide, drill
matching 1/8” holes into the curbs. Be sure the mitered
ends are tight against each other. Secure the anchor
plate to the curb sections with four #8 x 1/4” truss
head screws [B]. Be sure there is no gap in the mitered
joint when tightening. Drill and install two screws
through the round holes in the bracket as well .
Assemble the three header sections [C] in the same
manner, if necessary.
** Skip step #2 if header and curb sections are pre-assembled **
INTERIOR
3/16” DIA
5/16”
3/8”
CURB
ASSEMBLY
SILL
PENCIL
MARKS
3 Using a 3/16” high speed steel drill bit, drill
the interior face of the curb at both ends as shown.
These holes may be predrilled from the factory.
Place the curb assembly on the shower sill. The
assembled curb will sit near or on the center line of the
shower sill. If required, use a file to round the ends of
the curb assembly to tightly fit the shower opening.
Mark its location with a pencil along the interior and
exterior the full length of all three curb sections.