Installation Guide

QCI0237 Page 10 of 10 Certified 11/01/10
16 Cut the eight (8) pieces of the horizontal vinyl [V]
1/2” longer than the horizontal opening. Cut both ends of
the vinyl with a back mitre so that they sit tight against
the face of the vertical vinyl. (see illustration)
Starting at the top on the exterior
, place the vinyl against
the glass (open side against glass) and press into the header
at both corners. Continue pressing vinyl into the header
from both ends working toward the middle.
Install the top interior vinyl on the same panel.
Repeat the above steps for the bottom of the panel as
well as both the top and bottom of the other panel.
HORIZONTAL
OPENING
HEADER
CURB
HORIZONTAL
VINYL
GLASS
PANEL
VINYL
REMOVE
17 Carefully silicone the seam between the walls
and the wall jambs as well as the curb and threshold
on the inside of the shower
.
NOTE: Silicone on the exterior seam is optional.
DO NOT
USE the shower until the silicone is
completely cured. Check the tube of silicone
for the manufacturer recommended cure time.
(typically 24 - 48 hours)
NOTE: Do not silicone over the weep holes
SILICONE
INTERIOR FACE
OF HEADER
DECAL
18 Peel off the backing on the BASCO decal [W]
and apply it to the inside surface of the header.