Installation Guide

10 Place the Bottom Guide [V] on the track with the inner panel in the guide. Center the Guide on the width
of the track.
Using the holes in the Bottom Guide [V]to position scr ews, secure the guide using
2 SCR24 Guide Screws [W]
.
QCI5017 Rev. 2 Page 7 of 9 Certified 12/15/16
VIEWED FROM INSIDE
VIEWED FROM INSIDE
PRO-TIP:
While the included screws are self drilling,
installation of the Guide Screws [W] can
be made easier with a pilot hole:
1) Slide the Center Guide into its final
position.
2) Mark the location of the screw holes on
the tub track.
3) Drill 1/8” pilot holes at each marked
location
4) Replace the guide and install the screws.
They will finish drilling their holes and
thread the hole as they turn.