Installation Guide

7 If not already attached, attach the Black Rollers [M]

to the door Hanger Brackets

[H]

as shown using the #8-32 x 3/8”

Hex Head Screws

[N]

. The rollers should be approximately in the

center of the slots of the bracket fins.

From the outside of the shower, lift the inner panel into place

with the rollers (and textured side of glass) facing you.

Lower it into the shower and then lift it into the header.

Be sure the bracket fins and rollers are above the track groove.

Carefully lower the panel until the rollers are seated into the groove.

Slide the panel to one side and repeat the steps, lifting the

outer panel into place.

Check for alignment along the bottom and sides of each panel

and adjust the rollers as necessary.

9 Slide one of the clear plastic discs

[R]

, then

a glass hole sleeve [K] onto the threaded back plate

[P]

Push the assembly through the hole in the glass panel

so that the glass hole sleeve is flush with the other side

of the panel. Slide the other clear plastic disc onto the

protruding threaded part of the back plate, and then

slide on the front plate

[S]

. Repeat this for the second

hole on the panel. While holding the towel bar [U] in

place, and screw the back plates into the towel bar. Use

the provided Allen wrench and the small hole drilled into

the side of the back plate to fully tighten the towel bars.

NOTE: Outer panel has towel bar facing Out.

Inner panel has towel bar facing In.

Refer to the diagram in step #1.

QCI5017 Rev. 2 Page 6 of 9 Certified 12/15/16