Installation Guide

SILICONE
QCI5017 Rev. 4 Page 5 of 9 Certified 11/2/18
4 Before replacing the track, force a slight
downward bow into it. This will ensure that the
track fits tight to the threshold in the middle.
Run a bead of silicone on both flat surfaces on the
bottom of the track. Then replace the track onto the
threshold using the pencil marks from step #3 as a
guide. Be sure the raised side is on the exterior.
5 Replace one wall jamb and attach it to the wall with
one #8 x 2” truss head screw [D] in the center hole.
Check the wall jamb for plumb and tighten the screws.
Repeat for the other wall jamb.
NOTE: Careful not to overtighten.
Install a Bumper [E] dekram eht ni wercS daeH ssurT eht rednu
Top and Bottom holes.
Repeat with the other wall jamb.
Alternative Method:
Run 2 beads of silicone inside the
pnecil marks on the threshold.
Place the tub track in position over
the silicone, lining it up with the
pencil marks on the threshold from
the previous step.
NOTE: Be sure that the ears on the bumper install over the wings of the wall jamb