Installation Guide

Slide the door handle [U] with magnet onto the

strike edge of the door panel [L]. Close the door and slide the

handle up or down until the two magnetic strips are aligned.

Useapencil or masking tape the mark the location of the

handle on the door.

Slip the door handle vinyl [V] onto the door between the

marks and carefully drive the door handle on the door panel

(USING RUBBER OR PLASTIC MALLET). Spraying glass

cleaner or water onto the vinyl and handle will make the

assembly easier.

Close the door and check the clearance with the strike jamb.

If necessary, loosen the se

t screws [N] on the top & bottom

pivot blocks [P] and adjust the door to align the strike

magnets. When the door is properly aligned, tighten the set

screws securely.

Clean the inside edge of the bottom door rail and

the flat side of the drip rail thoroughly with rubbing alcohol

to ensure proper adhesion of the double stick tape [B]. Unroll

the tape and carefully attach it to the back of the drip rail (do

not peel the tape backing yet).

Insert the tapered drip vinyl [X] into the drip rail. Position

the drip rail flush with the bottom and pivot side of the door

panel [L], then raise the strike side until the bottom edge of

the drip vinyl is parallel to the curb [A]. Mark the location of

each end of the drip rail with a pencil. Peel off the t

ape

backing and carefully press the drip rail to the door in the

position marked.

Adjust the drip vinyl [X] by sliding it left or right

until it just touches the curb. Trim the vinyl (flush with the

pivot end and notch 1/2” longer than the drip rail as shown

on the strike end). Secure it with one #6 x 3/8” truss head

screw [F] in the pivot end of the drip rail.

The drip plug [Y] is supplied with a left and right hand plug

together. Break the right and left drip plug apart and insert

the appropriate plug into the high (strike) side of the drip rail.

Discard the unused drip plug. Peel off the tape backing and

carefully press the drip rail to the door in

the marked

position.

NOTE: Cleaners with alcoho l content can dissolv e the

adhesive that attaches the drip rail. To prevent this

possibility, place a small bead of clear sealant at the top

of the drip rail where it is attached to the bottom rail.

QCI5020 Rev 0 Page 7 Certified 06/21/2016