Installation Guide

The Frameless Pivot Shower Door is completely
reversible and may be installed pivot right or pivot
left. Refer to the illustration to determine the correct
position for your installation. For maximum
waterproofing, the pivot jamb should always be
opposite the shower head. These instructions depict a
pivot-left installation.
CAUTION: For safety, the door must always open
outward.
Note: The unit may be installed without
using the sloped curb [A] provided. Its use is definitely
recommended for positive water control on shower sills
with little or no slope.
Measure the wall to wall opening at the shower sill and
cut the curb to the exact length. File the ends of curb as
necessary to fit the corner contours of the enclosure.
Place the curb on the shower sill with the RAISED
portion to the exterior of the enclosure. Make sure the
curb is centered on the sill and lightly mark its position
on the sill with a pencil. Remove the curb from th
e sill.
Run two beads of caulk along the flat surfaces
on the bottom of the curb [A]. Then replace the curb on
the shower sill in the exact position marked in Step #2.
Press firmly into place with the raised portion to the
exterior of the enclosure.
NOTE: Improper caulking will result in leaks.
2
3
QCI5020 Rev 0 Page 4 Certified 06/21/2016