Installation Guide

HINGE LEFT HINGE RIGHT
ALSO
CORRECT
MEASURE
SHOWER
SILL
CURB
WEEP HOLE
INTERIOR
CURB
CURB
INTERIOR
WEEP HOLE
WALL
JAMB
WALL
JAMB
WALL
1 The Shower Enclosure is completely reversible
and may be installed hinge right or hinge left. For
maximum leak protection, the hinge side should be
opposite the shower head. Using the illustration,
determine the proper hinge side for the door. This
instruction sheet depicts a hinge-right installation.
Careful as to not follow the illustrations exactly.
CAUTION: For safety reasons, the door must
always open outward.
TIP: Temporarily cover the drain on the inside
of the shower with some tape or a large peice of
cardboard to prevent small screws, drill bits, etc
from disappearing.
2 Measure the finished wall-to-wall opening
at the shower sill. Cut the curb (w/ weep holes) [A]
to fit the full width of the opening. If necessary, file
the ends or corners of the curb to tightly fit the opening.
Place the curb in the center of the sill with the weep
holes facing the shower. Mark it’s location on the sill,
both inside and outside, with a pencil the full length
of the curb.
TIP: Use two pieces of tape over the top of the curb
to temporarily hold it in place.
3 Place one wall jamb [D] into the curb against the
wall. Using a level, plumb the wall jamb and mark the
hole locations on the wall with a pencil. Repeat this step
for the other wall jamb. Remove all parts and drill the holes.
Tile or marble walls:
Drill 3/16” diameter holes into the walls and insert the
plastic wall anchors [B].
Fiberglass or acrylic units can be done two different ways:
If the walls are not reinforced, drill 3/16” diameter holes
and insert the the plastic wall anchors. (Toggle bolts may
be used instead but they are not provided).
If the walls are reinforced, only drill 1/8” diameter holes.
QCI5230 Rev 0 Page 4 Certified 06/20/2016