Installation Guide
 WALL
 JAMB
9  Center the door in the opening by sliding the hinge 
jamb over the wall jamb (or 180° post) until the hinge jamb 
is plumb and the space between the door glass and header 
is even from hinge side to strike side. Drill two 1/8” holes 
thru the hinge jamb and into the wall jamb approximately 
1” from the ends of the jambs at the top and bottom and 
approximately 3/8” from the edge of the open side of the 
hinge jamb. (see illustration) Drill a third hole in line with 
the first two and centered between them. Enlarge the three 
holes in the hinge jamb only with a 3/16” drill bit for 
clearance of the truss head screws. CAREFUL: DO NOT 
enlarge the holes in the wall jamb (or 180° post). 
Attach the hinge jamb permanently with three #8 x 1/4” 
truss head screws.
Slide the snap-in fillers tight against the hinge jamb. Slide 
the strike jamb tight against the snap-in fillers. With the 
hinge jamb plumb and both fillers tight between both jambs, 
the strike jamb will also be plumb and parallel to the hinge 
jamb. 
Drill and attach the strike jamb in the same manner as the 
hinge jamb.
3/8”
180˚
POST
1“
1 1/8” -
 1 1/2”
1”
#8 x 1/4”
SCREWS
STRIKE
JAMB
DOOR
PANEL
ASSEMBLY
HEADER
3/8” - 
3/4”
10 Clean the bottom door rail and the drip rail [M] 
thoroughly with denatured alcohol to ensure proper adhesion. 
Unroll the double stick tape [N] and carefully aply it to the 
flat back side of the drip rail. 
(DO NOT peel the tape backing yet) 
Insert the tapered drip vinyl [O] with the short side of the 
vinyl on the hinge side of the rail. 
Position the drip rail so that the bottom is flush with the 
bottom of the door rail on the hinge side, and is 1/16” 
from the continuous hinge jamb. (see illustration)
Raise the drip rail on the strike side until the bottom 
edge of the tapered drip vinyl is parallel to the curb. 
Mark the horizontal location of the drip rail on both 
sides.
DOOR
RAIL
DRIP
RAIL
TAPERED
VINYL
ALIGN
(HINGE
SIDE
ONLY)
STRIKE
SIDE
HINGE
SIDE
1/16”
PARALLEL WITH CURB
MARK
MARK
QCI5230 Rev 0 Page 7 Certified 06/20/2016










