Operation Manual

INSTRUCTION MANUAL FOR DISHWASHERS
Page 8 of 12
UK
4.8 Turning the dishwasher off
• Press ON/OFF (1), on the DISPLAY (4) the central segments will light up, indicating t
hat the
machine is powered.
4.9 Resin regeneration (*optional)
On machines with an internal softener, when the regeneration cycle led lights up red (Fig. 11
) you need
to run a regeneration cycle to restore proper function of the internal softener. Proceed as follows:
• Empty and clean the dishwasher.
• Remove the integral filter and open the salt container in the tub.
• Pour in 250-300g of regeneration salt (1or 2mm grain size kitchen salt with no additives).
• Close the container firmly.
• Make sure the overflow has been removed
• Close the door and switch the dishwasher on.
• Press the PROGRAMME SELECTION button (2) to select the regeneration cycle.
• Press the START button (3) to start a cycle.
• The regeneration cycle lasts around 20 minutes.
• The dishwasher will switch off when the cycle has completed.
N.B. Do not switch off the machine if a regeneration cycle is underway
4.10 Displaying information
With the machine on, hold the PROGRAMME SELECTION button (2) down for five seconds until “CC
”
appears, followed by the number of wash cycles carried out during the machine life.
4.11 List of viewable messages
Door open Number of cycles carried out
4.12 End of shift
• At the end of the day always drain the machine as described in the section Machine draining.
• Disconnect the power supply by means of the main switch and close the external water cock.
• Perform routine maintenance and clean the machine as described in the section Maintenance.
• If possible, leave the door ajar to prevent bad odours building up inside the machine.