Operation Manual

INSTRUCTION MANUAL FOR DISHWASHERS
Page 7 of 12
UK
4.4 Cycle selection and start-up
4.4.1 Under-counter dishwashers
• Press the PROGRAMME SELECTION (2)
button repeatedly to select a wash cycle that is suitable
for the dishes to be washed; the cycle LED lights up to indicate the cycle chosen (Fig. 4).
• To run the programme, press START (3); the CYCLE LED (5)
corresponding to the chosen wash
cycle starts to flash.
• When the cycle is completed, it stays on, fixed.
• For rapid drying, remove the rack from the machine as soon as the cycle finishes.
• To stop a wash cycle early, press the START button (3).
4.4.2 Hood dishwashers
• Press the PROGRAMME SELECTION (2)
button repeatedly to select a wash cycle that is suitable
for the dishes to be washed; the cycle LED lights up to indicate the cycle chosen (Fig. 4).
• Press START (3), the AUTOMATIC START LED (7) lights up.
• Lower the hood; the cycle starts automatically and the CYCLE LED (5)
corresponding to the
chosen wash cycle starts to flash.
• When the cycle is completed, it stays on, fixed.
• For rapid drying, remove the rack from the machine as soon as the cycle finishes.
• To stop a wash cycle early, press the START button (3).
4.5 Continuous washing (*optional)
• This is an extended cycle; the time varies according to the model.
• The cycle duration may be varied as required by pressing START (3)
during the wash cycle, to
interrupt the wash and start the rinse phase.
4.6 Removing the integral filter
• Move the washing and rinsing arms at right angles to the edge of the door (Fig.7).
• Lift each semi-filter by the relative handle.
4.7 Emptying the dishwasher
4.7.1 Appliances with no drain pump
• Switch the dishwasher off.
• Remove the integral filter if present (Fig.7 A).
• Pull the overflow upwards (Fig.8 B), and wait for the tub to drain completely.
• If necessary, extract the tub filter and clean (Fig. 8 C).
4.7.2 Appliances with drain cycle (*optional)
• Select the drain cycle using the PROGRAMME SELECTION button (2).
• If present, remove the integral filter (Fig.7 A).
• Pull up and remove the overflow (Fig. 9).
• Close the door/hood.
• Press START (3) to run the cycle.
• The machine runs a drain cycle with self-cleaning (*optional) and then switches off.
• If necessary, extract the tub filter and clean (Fig. 8 C).