Operation Manual

EN
page 32
The button “A” will light in white for a few seconds, while loading the software. After
loadingiscomplete,thebuttonwilllightinred.Thishappensonlyattherststartofthe
day of the machine.
 Thewaterllingofthewash-tankisdonebypre-heatingviatheboiler.
On the "B" display, the messages "FILLING WATER" and "HEATING" will alternate.
The display will read "HEATING", till wash-tank and boiler will reach the set temperatures.
During this process, the machine will not allow any cycle selection or start.
 Ifthemachineisinstandardconguration,withhotwaterin-feed(50°C),withnoextra
power, the “A” button will light in green after some 20 min.
2.2.2 Operation
• Inserttheracklledwithdishestowash.
The plates must be correctly placed in the rack (see pict. 4).
• SelectthewantedwashingcyclebypushingthegreenSTARTbutton"A".
filling water heating
The display will show in sequence all these available programs.
Once the wanted program is displayed, do release the button.
Available programs for machine with a 40 mm rack:
Available programs for machine with a 50 mm rack:
Fig. 4
standard cycle
short cycle
standard 70°c
long cycle
clean long
clean long
long cycle
medium cycle
long 70°C
glasses 70°C
clean standard
clean standard