Operation Manual

EN
page 31
2. OPERATION
2.1 Control panel and relative symbols
A) START push-button to start up cycle / select cycle
B)Display
C) Switching – On / STAND BY button
D) Regeneration push-button (optional)
E) Drain Push-button
2.2 Machine start-up
2.2.1 Start-up
• Checkifthepumpsuctionlterisproperlyinsertedinitsseatinthewash-tankbottom
(see picts. 2 and 3).
 Thisltermustbecleanedevery20wash-cyclesorwhenevernecessary.
 DONOTusetheappliancewithoutthelters.
• Putthesurfaceltersinplace(seepicts.2and3).
• Shutthedishwasherdoor.
• Turnthewatervalve“open”.
• TurnthemainpowerswitchON.
• Themachineison"STAND-BY".
In the "B" display, the message "STAND-BY"will appear.
STAND-BY
• Turnthebutton"C".
The machine start will be active when the "A" button will light.
On the "B" display the "STAND-BY" message will be off.
Fig. 1
Fig. 2
(for machine with a 40mm rack)
Fig. 3
(for machine with a 50mm rack)