Operation Manual

EN
page 35
The circuit board is designed to call periodically for a 20 min. manual regeneration cycle.
This regeneration cycle can also be activated by the user, should the rinse quality be
dissatisfactory.
When the display shows “PRESS WATER SOFTNER REGENERATION KEY"
or when the users want to activate the “R” regeneration cycle, start the following
procedure:
• Shouldthedisplayshow"SALT LEVEL",llthespecialcontainer,placedontheinside
of the tank, with coarse salt (1-4 mm. grains), being careful not to spill it into the sump. A
strong concentration of salt can negatively affect the correct functioning and service life of
themachineandgeneraterustandthesteeloxidation.Afterllingwithsalt,locktheplug
tightly.
• Withthemachinein"STAND-BY" mode, the water valve open, the wash-tank empty
and the door shut, press the "D" button. The button "A"willstartashinginblue.
• Duringthiscycle,thedisplaywillshowthestepsinprogressandthetimeremaining.
• Thiscyclecannotbeinterruptedandthenormaloperationisinhibited.
• Atthecycleend,themachinewillswitchin"STAND-BY" mode, automatically.
At this moment, it is possible to switch the machine OFF (see par. 2.2.3 Switching OFF) or
start a normal operation phase(see 2.2.2 Operation).
In case of water hardness above 35°f an external water softener is recommended.
press water softner
regeneration key
%%%%%
SOFTNER REGENER
STAND-BY