User Guide

- 24 -

• See that the cable does not touch any heat sources or sharp edges. Do not let the

cable dangle over the counter edge.

WARNING! Hot surface!

During operation some parts of the device become very hot. In order to avoid

injuries do not touch any hot parts!

• Do not use the device if it does not function properly, has been damaged or dropped.

• Do not use any accessory or spare parts that have not been recommended by the

manufacturer. These can be dangerous for the user, or lead to damage of the

device or personal injury, and furthermore invalidate the warranty.

• Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep

the cable away from operating range and do not dunk it into water.

• When the unit is in use, never touch the spiral screws or any other moving parts.

• Do not move or tilt the device when in operation.

WARNING! Hazard via electrical current!

The device may cause injuries due to improper installation!

Before installation, the local power grid specification should be compared with

that of the device (see type label).

Connect the device only in case of compliance! Take note of the security advice!

5.2 Operating

Preparing the device

1. Clean the worm screw (2), the

tower (3), the top (3a) and the

lower bowl (4) with washing liquid

and rinse them with clean water

and then dry them.

2. Install the lower bowl (4) and then

the worm screw (2).