User Guide

- 4 -
• Drill two holes in the wall.
• Leave a space of 280 mm between the holes, as
shown in figure 2.
• Insert the dowels and screws included with the
unit into the drilled holes and hang the basin on
them.
Fig. 2
• Connect the basin to the water supply using the
included assembly kit. The basin may be
connected to either hot or cold water, or both.
• Connect the basin to a drain pipe.
• The basin is activated by pressing the plate at
the front with one’s knee (fig. 3).
• Water will flow from the tap for approx. 15
seconds. After this time the flow will
automatically shut off.
Fig. 3
• The proportion of hot and cold water is controlled using
the regulating screw (fig. 4).
Washing
• Wash the basin regularly using a soft cloth and non-
abrasive cleaning substance.
Fig. 4
Bartscher GmbH
Franz-Kleine-Str. 28
D-33154 Salzkotten phone: [phone]
Germany fax: [phone]