User Guide

- 23 -
• Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
• Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
5.2 Installation and connection
• Discard the complete packing material after unpacking the device.
• Place the device on top of an even and safe surface which supports the weight of the
device and is not heat sensitive.
• Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
• You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
• The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
• Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.3 Operating
• Set the ON-/OFF- knob at the back of the device to the position marked „OFF“.
• Connect the device to a single outlet.
• Place the dish to be cooked on the hot plate.
NOTE!
Do not use unstable dishes that may easily be upset for cooking.
Use dishes with a flat bottom in order to ensure total contact with the hot plate, to
ensure maximum use of generated heat.
• Turn the ON-/OFF switch to the position marked „ON“.
• Set the temperature desired using the regulator for a given hot plate. The orange control
light will come on.