Use and Care Manual

INSTALLATION AND ADJUSTMENT
9
1. Take two ends of exhaust hose and its adapter assembly.
2. Put front end of exhaust hose assembly onto jugged position of exhaust outlet of back panel.
3. Keep the right direction of slant side A of adapter, for ease installation of window seal-plate.
4. Hold the unit by one hand, carry the exhaust hose assembly with another hand and push it into unit gently,
for good lock of two parts.
Keep the right direction of slant side A of adapter, for ease installation
of window seal-plate.
Keep exhaust hose assembly be strongly locked by fasteners in
exhaust outlet to avoid its fall off.
Installation of window seal-plate:
1. Open the window in half, put the seal-plate into window, determine in vertical or horizontal position
according to window open direction.
2. Extend seal plate parts, adjust it to the length of window and x it with screws then.
Installation of the unit:
1. Move the unit together with its exhaust hose assembly in front of the window and keep the unit at least
50cm away from the walls or other objects.
2. Install the rectangle end of exhaust hose adapter into the corresponding rectangle hole in window seal-
plate assembly, x it with screw and close the window.
Align the 4 openings on window seal-plate with corresponding 4 openings on exhaust hose adapter
and set them together, then slide adapter downwards, to make 2 set of openings locked for 2 parts
good connection. A. Lock self-tapping screw φ4 mm into adapter hole.