Manualshelf

Use and Care Manual

ManualsBrandsBarton ManualsOutdoor Heating1500-Watt Indoor/Outdoor Patio Electric Halogen Heater Lamp Ceiling Mount
12345678
INSTALLATION / OPERATION
3 4
INSTALLATION INSTRUCTIONS
A. Heater must be installed by a qualied electrician.
B. Place the heater on a rm, level ceiling surface; level ceiling surface; installaon of the heater on a
strong rigid support (such as strong wooden beams or metal rails etc).
C. The Hook on the ceiling hanging the Pao Heater must be able to take a weight 3 or 4 mes that of the
Pao Heater itself.
D. Place the Hook A around the Ceiling Hook and clip on any Ring of the Chain to adjust the height of the
Pao Heater to the Floor.
E. The distance between the boom of the Pao Heater to the Floor must be over1.8M.
F. Plug the Pao Heater into a grounded 110-120V 50-60Hz power outlet.
G. Only operate the heater when it is in the upright posion.
• Plug the Pao Heater into a grounded 110-120v 50-60Hz power outlet
• Only operate the heater when it is in the upright posion.
• Our Electric Pao Heater is equipped with Three heat sengs
• The ON-OFF switch on the heater is used to control the power of the heater.
WARNING: The heater must be properly installed before it is used This unit is equipped with one heat
seng On I O.
REMOTE CONTROL
A. Press on the On/O switch to acvate the heater
B. To operate the heater on high power (800W), press on the le side buon of the remote control
C. To operate the heater on low (700W), press on the right side buon of the remote control
D. Press on both the le and right side buon of the remote control for maximum power (1500W)
E. To operate the LED light, press the top buon of the remote control
The main power switch must be turned on to use the remote control
ACTIVATION BUTTON
A. Press on the On/O switch to acvate the heater
B. Press on the buon once to operate the heater on low (800W) power.
C. Press on the buon twice to operate the heater on high (1500W) power.
D. Press on the buon three mes to acvate the LED ambient lighng without heat.
E. Press on the buon four mes to acvate the LED ambient lighng and to operate the heater on high
(1500W) power.
F. Press on the buon ve mes to shut the light and heat o.