Instructions / Assembly

7
ASSEMBLY
7. Attach the knob (8) to the front panel (7) with one M4
washer (D) and one M4x8 screw (C).
8. Turn the assembles pieces upside down and connect
the front panel with the left front legs (3).
9. Connect the hose and regulator to the cylinder. The propane gas and
cylinder are sold separately. Use a standard 20lb. propane cylinder only.
Use this heater only with a propane vapor withdrawal supply system.
Storage of an appliance indoors is permissible only if the cylinder is
disconnected and removed from the appliance. A cylinder must be
stored outdoors in a well ventilated area out of reach of children. A
disconnected cylinder must have dust caps tightly installed and must
not be stored in a building, garage or any other enclosed area. The
maximum outlet gas supply pressure” 250psi, the minimum inlet gas
supply pressure: 5psi.
The minimum hourly rating of 10000 BTU is required for a heater for
automatic operation at ratings less than full input rating.
The pressure regulator and hose assembly supplied with the appliance
must be used. The installation must conform with local codes, with
national fuel gas code ANS Z223.1/NFPA54, natural gas and propane
installation code CSA V149.1, or propane and handling code B149.2.