Instructions / Assembly

Picture 1

Picture 3

Picture 5

Picture 4

Picture 2

PREPARATION

Step 1: Follow “ASSEMBLY INSTRUCTIONS” to install burner and assemble unit.

Step 2: Place stove on a level and stable surface.

Step 3: Make sure the propane tank is turned OFF, connect propane tank and

stove with regulator and hose.

GAS LEAK TESTING

Step 1: Slowly open propane tank valve and check for leaks by applying small

amount of liquid soap and look for bubbles. If you smell gas, TURN OFF the

propane valve immediately.

Step 2: Detach and reconnect the regulator on tank and test it again, if leaking

continues, please stop using and contact retailer/distributor for help.

Step 3: If no gas is detected, follow Part Three OPERATION.

Step 1: Hold a fire lighter near the burner (Picture 2).

Step 2: Open regulator valve slowly ( Picture 3 to the “ON” position).

Step 3: Put regulator knob to “OPEN” position (Picture 4), please note that these

two knobs are individual.

Step 4: If the flame is not blue, please use installing tools to release screws on the

air damper (Picture 1), slowly adjust the air damper up and down until burner has a

blue flame, some yellow tipping of the flame is normal. Then screw the air damper

tight when you gain blue flame.

Step 5: Place the stainless steel oil tank, fryer basket on burner. (Picture 5)

Step 6: To

gain necessary flame height and heat by rolling regulator. (Picture 3).

Step 7: Use different temperatures

for cooking different foods, please use the

thermometer to test oil first.

OPERATION