Owner's Manual

5
COMPLIANCE STATEMENTS
FCC COMPLIANCE STATEMENTS FOR WC20
FCC PART 68 NOTICE
This equipment complies with FCC Part 68 rules. The FCC registration number and
Ringer Equivalent Number (REN) are printed on a label attached to the bottom of the
enclosure. You must, upon request, provide this information to your telephone company.
The REN number is used to determine the maximum number of devices that may be
connected to the phone line and still have all those devices ring when your number is
called. To determine the number of devices that may be connected to your line, as
determined by the REN, contact your local telephone company.
If your telephone equipment causes harm to the telephone network, the telephone
company may discontinue your service temporarily. If possible, they will notify you in
advance. If advanced notice is not practical, you will be notified as soon as possible. You
will be informed of your right to file a complaint with the FCC.
If there is a problem with the telephone network, the telephone company may ask you to
disconnect your equipment from the telephone line until the problem has been corrected
or until it is determined that your equipment is not malfunctioning.
Your telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the proper functioning of your equipment. If they do, you will
be notified in advance to give you an opportunity to maintain uninterrupted telephone
service.
This equipment cannot be used on coin service provided by the telephone company.
Connection to party lines is subject to state tariffs.
There are no user serviceable parts in this modem. If there is a problem or the modem
needs to be repaired or serviced, return it to the company where it was originally
purchased.
FCC applicable REN number is 0.6B.
FCC PART 15 NOTICE
This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures: re-orient or relocate the receiving antenna, increase the separation between the
equipment and receiver, connect the equipment into an outlet on a circuit different from
that to which the receiver is connected, and/or consult the dealer or an experienced
radio/TV technician for help.
The user is cautioned that changes and modifications made to this equipment without
approval of the manufacturer could void the user’s authority to operate this equipment.
Contains Transceiver Module, FCC ID: OKZ-WC20-2040B.
WARRANTY AND REPAIR SERVICE IN THE USA:
Barton Instrument Systems
900 South Turnbull Canyon Road
City of Industry, CA 91745
1-800-291-3550, ext. 269 or [phone]