Data Sheet

Josef Barthelme GmbH & Co. KG
Oedenberger Straße 149
D-90491 Nürnberg
www.barthelme.de
[e-mail]
Technische Änderungen und Irrtümer vorbehalten. / Subject to technical changes and errors.
Vorläufig / Preliminarily
Datum / Date: 10.2012 AS2 Revision: 1.1 Seite 2 von 2
− Bei Einsatzbereichen mit Einfluss von Staub oder Feuchtigkeit ist der LED-Streifen mit einem Gehäuse/Profil mit einer
geeigneten Schutzart zu schützen. Das Modul kann durch eine nachträgliche Lackierung gegen Kondenswasser und Feuchtigkeit
geschützt werden. Der zu verwendende Lack muss folgende Eigenschaften erfüllen:
⇒ Transmissionsfähigkeit
⇒ UV-Stabilität
⇒ Temperaturzyklenbeständigkeit im zugelassenen Temperaturbereich
⇒ niedrige Wasserdampfpermeation bei allen Klimaten
⇒ Beständigkeit gegen korrosive Atmosphären
Verwenden Sie ausschließlich von uns freigegebene Lacke und Silikone!
Security advice:
− Mechanical stresses of the devices on the LED modules are to be avoided!
− During the mounting process the PCB may not be damaged or interrupted.
− Only an electronically skilled person is allowed to do the installation of LED modules (with power supply) in consideration of all
valid instructions and norms.
− Please pay attention to the polarity! With an incorrect polarity, there will be no light emission or the LED module can be damaged!
− Only a secure operating state submits a parallel connection. Please avoid a series connection of the LED module. Unsymmetrical
voltage drop may cause a strong over-loading and destruction of single modules.
− Please pay attention to the dimensioning of your available power supply; dimming is only possible with PWM, or similar.
− To avoid any short circuits at the solder patches by mounting on metallic surfaces, there should be an insulator between
module and mounting surface.
− A sufficient cooling has to be respected, e.g. by sticking to metallic surfaces.
− Please be aware of ESD while mounting.
− The LED strip will be delivered unvarnished, i.e. without corrosion prevention.
− Corrosion defects caused by the contact with condensation or humidity cannot be granted.
− By using the LED strip in a field of application with the influence of dust or humidity is to protect properly. It can be protected
against condensation or humidity by lacquering afterwards. The lacquer must have the following features:
⇒ Ability to transmit
⇒ UV ray resistance
⇒ resistance temperature cycles in the approved temperature range
⇒ low water damp permeation by all climates
⇒ resistance to corrosive atmospheres
Only use lacquers and silicones approved by us!