Datasheet

Technische Änderungen und Irrtümer vorbehalten. Subject to technical changes and errors.
Vorläufig / preliminarily
Datum / Date: 09.2012 AS2 Revision: 1.9 Seite 3 von 3
Security Advice
− Mechanical stresses of the devices on the LED modules are to be avoided!
− During the mounting process the PCB may not be damaged or interrupted.
− Only an electronics skilled person is allowed to do the installation of LED modules (with power supply) in consideration of all
valid instructions and norms
− Please pay attention to the polarity! With an incorrect polarity there will be no light emission or the LED module can be
damaged!
− Only a secure operating state submits an electrical parallel connection. Please avoid an electrical series connection of the LED
module. Unsymmetrical voltage drop may cause a strong over-loading and destruction of single modules
− To avoid any short circuits at the solder patches by mounting on metallic surfaces, there should be an isolation between module
and mounting surface
− The maximum length of an associated LED module is approximately 5.0m. According longer LED modules are intermediate
feeding or feeding at the beginning and end of the LED module is possible.
− There must be a sufficient cooling to be respected, e.g. by sticking to metallic surfaces
− Please be aware ESD while mounting
− Corrosion defects caused by the contact with condensation or humidity can not be granted
− The maximum current per reel (max. length) is for a short time 5 Ampere (RGB). With using from a power supply with an output
current of greater than 5 Ampere must the module pursuant to fuse with a super quick protection.