User manual

POLARIS Remote 19.1" / Remote 15"
33
Page 33
The local unit is compatible with the following devices:
PC PC/AT, PS2 and 100% compatible clones
Keyboard PC/AT enhanced keyboard. Some older XT/AT autosensing
keyboards may not be compatible.
PS/2 mouse Standard PS/2 mouse, Microsoft Intellimouse, Logitech
three-button mouse
Monitor SVGA, VGA, XGA, RGB (Sync on Green)
6.2.6 The local unit is compatible with the following devices:
■ Connect the local unit to the PC and the two devices with two fibers 62.5 µm,
50 µm or 9 µm.
■ Power on your PC and check that the keyboard operates correctly. Boot an operating
system (such as WINDOWS) or application you intend to use. Check the mouse function
(if required).
We recommend that the complete system is tested in one room before permanent
installation. If a long interconnect cable is not available, us a patch cable or test basic
unit operation with your PC.
All necessary configuration and video tuning is done automatically. Special configuration and video tuning is carried out
using the keyboard connected to the POLARIS Remote. A hot-key sequence is used to enter command mode where
settings may be adjusted and certain modes of operation configured (see the IHSE manual for technical details).
Further information:
Further information on the functions of the local unit can be found in the IHSE manual at www.ihse.com
DMXI Data sheet: http://www.ihse.de/pdf/i421-xx_e.pdf
Manual: http://www.ihse.de/pdf/b421-xx_e_1.10.pdf
DDXI Data sheet: http://www.ihse.de/pdf/i437-xx_e.pdf
Manual: http://www.ihse.de/pdf/b437-xx_e.pdf
Please read the manual carefully and also pay attention on the warning of the manufacturer.