User manual

POLARIS Remote 19.1" / Remote 15"
29
Page 29
6.1.7 Quick Startup
For advanced users, we recommend to take an overview over the system, by reading the ‘Quick Startup’ section:
■ Turn off your PC. Connect the POLARIS Remote to the voltage supply!
■ Connect the local unit to the PC and POLARIS Remote.
■ Power on your PC and check that the keyboard operates correctly. Note that the image quality
may be poor at this point. Boot an operating system (such as Windows) or application you intend
to use. Check that the mouse functions (if required).
■ Check the link integrity (LED at the local unit - flashing).
■ Enter Command Mode t + u + k .
■ Use Assisted EQ to get an approx EQ setting t +  ein.
■ Fine tune HF & LF EQ for the best picture. LF removes smearing and HF adjusts sharpness. You
may obtain a better result by slightly overcompensating the LF EQ before adjusting the HF EQ.
■ With cables, 100m+ it might be possible to obtain a better screen picture by processing Quick
Skew – Toggle GREEN Delay
(t + J) .
■ Exit Command Mode and save settings } .
Further information:
Further information on the functions of the local unit can be found in the IHSE manual at www.ihse.com
Data sheet: http://www.ihse.com/pdf/i434-Sx_e.pdf
Manual: http://www.ihse.com/pdf/b434-Sx_e.pdf
Please read the manual carefully and also pay attention on the warning of the manufacturer.