System information

IDM
Bluetooth
Reference Manual
Appendix
8014563/WE95/2012-07-25 © SICK AG · Germany · All rights reserved · Subject to change without notice 81
S
SS
S
System Commands
PROGRAM
(Enter Programming Mode)
Save Configuration
Sleep
FIN (Finish) Clone
Paging
END
(Exit Programming Mode)
Factory Default
IDM Set Up Link
(connection procedure see next page)
System Information List
(SYSLIST)
Master Default

Factory Default: After scanning” Factory Default” command, all parameters will be returned to factory default value (The radio link will be disconnected and the scanner will revert to uninstall state).

Master Default: After scanning “Master Default” command, the scanner will remain the pre-set parameters of Host Interface Selection, Keyboard Interface Control (except Record Suffix; Preamble;
Postamble), Serial Interface Control (except Record Suffix; Preamble; Postamble), Wand/Laser Emulation Control, Bluetooth Device Name, Bluetooth PIN Code & Out-of-range Scanning, the
rest of parameters will be returned to default value (The radio link is still keep on).
Save User Default User Default
 User Default: After configuring the IDM imager you can store your configuration via scanning “Save User Default”. When scanning “User Default” the scanner will load the
configurations that you’ve done before. Please note that when scanning “Master or Factory Default” the user default values will be deleted.