System information

Reference Manual
I
DM
Bluetooth
Configure Your IDM BT
8014563/WE95/2012-07-25 © SICK AG · Germany · All rights reserved · Subject to change without notice 71
S
SS
S
PROGRAM
Condensed DataWizard
♦
♦♦
♦ Data Replacer Setting ♦
♦♦
♦
Family Code Selection P.C Parameter Selection Option Code 2nd Option Code
Replacer Control
SS
MS
MS
Disable

Select one bar code symbology
Select all bar code symbologies
FIN
(2 digits)
00
automatic termination
automatic termination
1st Replacement
SS
DS
Disable

Enable
2-digits identified position; 1 replacement character
FIN
(2 digits)
position
[00-7F]
2nd Replacement
SS
DS
Disable

Enable
2-digits identified position; 1 replacement character
FIN
(2 digits)
position
[00-7F]
3rd Replacement
SS
DS
Disable

Enable
2-digits identified position; 1 replacement character
FIN
(2 digits)
position
[00-7F]

The Data Replacer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for replacer control, and provides Multiple Position Replcement in the identified position.

All data must conform to the Identified Bar Code Symbologies, and one to three Identified Characters in the identified position while the Data Replacer is enabled; it
arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.

Regarding the “Bar Code Selection” and “Position Calculation” of Data Replacer, please refer to page 65 for details.

Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find mathced HEX value.