System information

Reference Manual
I
DM
Bluetooth
Configure Your IDM BT
8014563/WE95/2012-07-25 © SICK AG · Germany · All rights reserved · Subject to change without notice 70
S
SS
S
PROGRAM
Condensed DataWizard
♦
♦♦
♦ Data Verifier Setting ♦
♦♦
♦
Family Code Selection P.C Parameter Selection Option Code 2nd Option Code
Verifier Control
SS
MS
MS
Disable

Select one bar code symbology
Select all bar code symbologies
FIN
(2 digits)
00
automatic termination
automatic termination
Identified Data Length
SS
MS
Disable

Enable
Determine the identified data length for verification.
FIN
(2 digits)
1st Identified Character
SS
DS
Disable

Enable
2-digits checking position; 1 identified character
FIN
(2 digits)
position
[00-7F]
2nd Identified Character
SS
DS
Disable

Enable
2-digits checking position; 1 identified character
FIN
(2 digits)
position
[00-7F]
3rd Identified Character
SS
DS
Disable

Enable
2-digits checking position; 1 identified character
FIN
(2 digits)
position
[00-7F]

The Data Verifier is used to provide advanced verification for error-free scanning and to work as an Embedded Data Transmitting Filter.

All data must conform to the Identified Bar Code Symbologies, Identified Data Length, and one to three Identified Characters in the checking position. Otherwise, the
IDM BT will not transmit the data to the host computers or terminals, but will instead issue 3 long beeps for verification error and skip the scanned data.

The Data Verifier checks only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.

Regarding the “Bar Code Selection” and “Position Calculation” of Data Verifier, please refer to page 65 for details.

Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find matched HEX value.