System information

IDM

Bluetooth

Reference Manual

Getting Started

8014563/WE95/2012-07-25

Using IDM BT in PICO Mode

Ensure the battery is fully charged and choose your desired interface cable, then plug it into the host interface port of the

smart cradle and connect it to the host device.

Turn on the power of your host device.

Ensure the side (IDM140BT cradle) or lower indicator (IDM160BT cradle) of the smart cradle give alternative red and

green blinks (in “Uninstall” state). If the smart cradle is paired with other scanners, you can press and hold the

paging/reset button for over 5 seconds to un-pair all paired scanners. Then smart cradle will return to uninstall state

automatically.

Prepare the scanners you desire to pair with smart cradle. Ensure the status indicator of each scanner give alternative

red and green blinks (in “Uninstall” state). If the scanner is not in uninstall state, please scan the “Uninstall” command to

un-pair the scanner. Then scan the “PICO mode” command, and the status indicator of scanner will turn steady red.

Uninstall

PICO Mode

Place the scanner on the smart cradle, then you will hear one short beep to indicate the pairing process is activated. The

scanner will give continuous short clicks and the link indicator of scanner will flash blue quickly during the pairing process.

When you hear 4 beeps in ascending tone, the pairing process is completed. You will see the link indicator of scanner

giving 1 blue blink per 2.5 seconds, the center or upper indicator of the smart cradle turning steady blue and its side

indicators turning steady green. If the scanner pairing process failed or it’s not placed on the smart cradle within 20

seconds, you will hear 2 “Di-do Di-do” beeps to indicate pair failure, the scanner will return to uninstall state automatically.

Scan the corresponding host interface quick set command to complete the installation.

Please follow the same procedures to pair the other scanners with the smart cradle.

For user’s convenience, the smart cradle will automatically assign the ID numbers to each scanner. After completed all

pairing processes, you can scan the “System Information” command to check the assigned ID number of each scanner.

USB PS/2 RS232