Programming Manual

i480e&i480e-MD2 Programming Manual
109 / 139
(The AG has both an active AND a held call);
2: Call on hold, no active call.
signal
Ranges from 0 to 5.
roam
0: roaming is not active;
1: roaming is active.
battery
Ranges from 0 to 5.
status
Values in the chapter 20.1.1.
Note
This command shall be sent after received the AGINDICATORSIND
indication.
20.25 AGOK
The AGOK command is used to send the OK command to the remote HF side.
Command
AT+B AGOK
Response
AT-B AGOK [status]
Parameters
status
Values in the chapter 20.1.1.
Note
N/A
20.26 AGERROR
The AGERROR command is used to send the ERROR command to the remote
HF side.
Command
AT+B AGERROR
Response
AT-B AGERROR [status]
Parameters
status
Values in the chapter 20.1.1.
Note
N/A
21 HFP AG Indication Definition
This chapter introduces the HFP (AG Role) relevant indications’ definition.
Barrot Confidential