Installation Instructions

Owner's Manual
Territory
Blinds
For parts call 800-345-6007 M-F 8-5 CST
SETUP INSTRUCTIONS:
1. Remove the blind from carrying bag.
2. Hold one of the outside rings and release the other
rings away from you. SEE FIGURE 1.
NOTE: The blind will pop open! Use caution.
3. Spread open the blind and anchor down with metal
stakes through the tie down loops located at the bottom
of blind. SEE FIGURES 2A AND 2B.
4. Extra stakes and tie down ropes are included for high
wind situations. Attach ropes to the loops located on
the outside of the blind at each corner, halfway up from
the ground.
TAKEDOWN INSTRUCTIONS:
1. Remove all ground stakes and zip up the doors and
windows.
2. Collapse blind down so it is at, lean the top of the
blind against yourself and grasp the top with your
hands at 10 and 2 oclock. SEE FIGURE 5.
3. Roll the top away from your body, folding the
blind in half, so the top edge is nearly touching the
bottom edge. SEE FIGURES6.
NOTE: It may be easier to nish take-town while in
a kneeling position.
4. Shift your right hand to 12 oclock and your left hand
to 9 oclock. Your left hand must remain above the
bend. SEE FIGURE 7.
5. While holding onto the blind with both hands, pull
your right hand, along the ground, towards your left
leg (moving from 12 to 7 oclock). At the same time,
push your left hand over the top of your right hand
(moving from 9 to 2 oclock). SEE FIGURE 8.
NOTE: The right side of the blind may SPRING UP!
Move slowly to minimize the spring. The blind
should collapse with ease. DO NOT force the blind!
UV WARNING
ULTRAVIOLET LIGHT BREAKS DOWN LIGHTWEIGHT FABRIC
FIBERS. THE MATERIAL WILL FADE, LOSE STRENGTH AND
EVENTUALLY DISINTEGRATE IF LEFT IN PROLONGED
SUNLIGHT. TO EXTEND THE LIFE OF YOUR GROUND BLIND,
AVOID LEAVING IT OUT IN DIRECT SUNLIGHT FOR EXTENDED
PERIODS OF TIME. SET IT UP IN A SHADY AREA WHENEVER
POSSIBLE. FADING OR DISCOLORING OF BLIND IS NOT
COVERED UNDER YOUR WARRANTY.
For parts call 800-345-6007 M-F 8-5 CST
6. While pinning the blind down with your left hand,
remove your right hand. Use your right hand to fold
down the right side of the blind. SEE FIGURE 9.
7. Pack the blind into its carrying bag. SEE FIGURE 10.
MAINTENANCE INSTRUCTIONS:
1. Never put blind away wet. Always put away dry to
avoid mildew.
2. Take down blind when not in use to avoid unnecessary
damage and fading.
3. Seal the seams with seam sealer and the walls and roof
with silicon spray if leaking occurs.
4. Use extra tie-downs during excessive winds.
5 6 7
8 9 104
POLE INSTALLATION:
NOT APPLICABLE FOR ALL MODELS
1. Insert each end of poles into opposite corner pockets.
Poles will cross at peak of roof. SEE FIGURE 3.
2. Tie a knot around poles at the peak of the roof to secure
poles in place. SEE FIGURE 4.
1
2A
2B
WARNING
THIS BLIND IS MADE WITH A HEAVY SPRING STEEL FRAME THAT
SPRINGS OPEN DURING SETUP. USE CAUTION WHEN SETTING
UP. KEEP AWAY FROM BODY AND FACE. KEEP CLEAR OF OTHER
PEOPLE WHILE SETTING UP.
ALWAYS BE AWARE OF OTHER HUNTERS. WHEN GUN HUNTING,
ALWAYS ATTACH A BLAZE ORANGE SAFETY CAP.
3