Installation & Assembly

e. Pre-drill holes and secure catch bracket with

three 16mm Phillips self-drilling screws (Fig. 12).

f. Slide the catch onto the bracket and position.

The removable spacer is attached to the front

handle base to ensure proper gap to engage the

striker.

The gap between the catch and the front handle

base should be no less than 1⁄8" (Fig. 13).

g. Once you align the catch on the bracket, secure

its position with one 24mm Phillips machine

screw. Rotate the screw clockwise to decrease

the gap, or counter-clockwise to increase the

gap (Fig. 14).

Adjusting The Handles

The handles are able to be positioned in a vertical

or horizontal orientation depending on your

preference.

a. Loosen the small screw under the shaft of the

handle (Fig. 15).

b. Position the handle to desired orientation and

tighten the screw (Fig. 16).

Inside Inside

of Postof Post

Fig. 12

Front Front

ViewView

Min 1/8"Min 1/8"

Fig. 13

Fig. 14

Fig. 15

Fig. 16

24mm 24mm

screwscrew

Remove Remove

ScrewScrew

Replace Replace

ScrewScrew

Removable SpacerRemovable Spacer