User's Manual Part 1

86 of 285
Enter Selcall ID number, four or six digits then press
the key:-
At this point Self IDs can be linked to the Selcall ID entered. This
means that when a call is made to this Selcall ID the self ID
associated with it will only be used. If no self IDs are available or
the self id associated with the destination address is deleted the
“Current Link is Invalid” message will be shown, otherwise the
“Input Link Status” message is shown. If a self ID is linked to the
Selcall ID then that Selcall ID can only be called on a channel that
is programmed for the Selcall type of the linked self ID.
In the example below whenever a call to “Perth 2060” is made the
transceiver self ID 9876 will be used and can only be sent on an
OEM enabled channel. If a non OEM channel is selected then
access to the “Perth 2060” address book entry is blocked.
Use the scroll keys to select the required “Linked to Self Id”
setting then press
key:-