Manual

CAB COMBINATION WORKSHOP SPECIFICATIONS

Part #8300011 Carbide wheels and diamond belts

Part #8300012 Diamond wheels and diamond belts

Part #8300010 Carbide configuration without motor, GFCI, switch & base board

Part #8300013 Diamond configuration without motor, GFCI, switch & base board

Part #8300014 No wheels, belts, blade, GFCI, switch, motor, base board or polishing

supplies

Horsepower 1/3 HP

Motor Voltage/Frequency 110 volt/60 Hz

Amperage 5.8 Amps

Motor RPM 1725

Motor Arbor Diameter 1/2"

Duty Continuous, automatic thermal protection shut-off

Motor Arbor Bearings Ball bearings, permanently sealed

Blade Capacity 6" diameter

Saw Lubricant Oil or water with rust inhibitor (Tool Cool)

Motor and Shaft Pulley 2" OD x 5/8" bore (shaft) and 2" OD x 1/2" bore (motor)

Shaft Bearings Permanently sealed 5/8" OD shaft ball bearings

Blade Arbor Flanges 2" OD x 5/8" bore aluminum

Maximum Depth of Cut Not to exceed 1" for most cuts

Brazed Diamond Wheel 80 and 200 grit

Diamond Resin Belts 400, 600, 1200 and 3000 grit 6" x 1-1/2" wide belt size

Expandable Rubber Drum 6" x 1-1/2" wide x 5/8" arbor

Shaft Type 5/8" precision-machined stainless steel

Wheel and Blade Flanges Aluminum 2" OD x 5/8" bore

Wheel Spacers 7/8" OD x 5/8" ID aluminum (length varies for wheels and drum)

Convex Polishing End Hub 6" aluminum hub disc with 5/8"-11 right hand thread

Lubricant capacity of reservoir tank: 1/4 gallon will cover 1/4" of 6" blade.

Pump: MK Submersible pump (part #155987-VP), variable flow control with 1/4" ID tubing.

Water Control Valves: 3 stainless steel control valves, brass lever cock valve with barb for 1/4" ID tub-

ing mounted on rear of the hood.

ON/OFF Switch Box: Lever operated switch box and pigtail female plug receptacle for submersible

pump.

Standard Polishing Supplies: Three 6" Polytex pads, three diamond paste syringes (5 grams ea.),

diamond paste (8,000, 14,000 and 50,000 grit), 6" leather buffing pad, 100 grit green silicon carbide

blade sharpening stick (1" x 1" x 6"), 3M On-Off cement, submersible pump, 1/4" ID clear tubing, 3/8"

ID clear tubing and GFCI.

CAB COMBO WORKSHOP SPECIFICATIONS